15A Standard Power Conditioner with Sequencer (M-8S)

15A Standard Power Conditioner with Sequencer (M-8S)

120 Volts 

The Merit M-8S Power Sequencer is an affordable AC power solution for rack-mount systems requiring power sequencing. With 6 delayed outlets, it sequentially powers up your equipment, supporting up to a 15-amp load. The unit features 3 delayed outlet banks, each with 2 outlets, plus 2 unswitched outlets for always-on devices.

Its built-in power filtration reduces noise caused by fans, lights, and power lines, ensuring cleaner sound. The sequenced outlets protect your gear by powering it up in stages, preventing speaker pops and potential damage. Known for its reliability, the Furman M-8S ensures consistent, clean power for your setup.

$514.95
Save $0.00
Quantity

or purchase from an Authorized Retailer

  • Description

  • Specifications

  • Warranty

  • Resources

Description

Easy Installation and Power Sequencing

The M-8S is designed for easy installation in the top slot of your rack. Once installed, the unit's six delayed outlets on the rear panel provide sequenced power-up, ensuring that your equipment powers up in stages. This reduces the risk of power surges that can damage your gear, especially your speakers and amplifiers. With a total load capacity of up to 15 amps, the M-8S can handle the power needs of a wide range of audio and video equipment.

The device includes three delayed outlet banks, each consisting of two outlets, which allows for flexible distribution of power across multiple devices. Additionally, the unit offers two unswitched outlets, which are always on, providing power to critical devices that require continuous power, such as lighting or other essential gear.

Advanced Power Filtering for Clean Sound

One of the most notable features of the M-8S is its power filtering technology. Did you know that most standard power sources introduce unwanted noise into your audio system? The hum from fans, the buzz from fluorescent lights, or even fluctuations in the power lines outside can all cause low-level background noise that can affect the clarity of your sound. Typical power strips can't address this issue, but the Furman M-8S can. With its advanced power filtration, the M-8S removes unwanted electrical noise, ensuring that your audio equipment delivers the clean, clear sound quality you expect.

Protect Your Equipment with Sequenced Outlets

Bars, clubs, and other event venues have some of the worst power out there—from air compressors turning on and off to light shows pulling current loads up and down, the AC power can strain the circuits in your rig. The advanced Series Multi-Stage Protection and LiFT from Furman keeps the bad stuff out, and the dual pull-out front panel lights let you discreetly see your board and gear without distracting from the show on the dance floor.

Technical Specifications

Family

Merit Series

Line Voltage

120 (Volts)

AC Cord

14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug

Convenience Outlet (Front Panel)

1 Un-switched NEMA 5-15R

Rear Panel Outlets

2 Un-switched NEMA 5-15R (1 duplex)

Sequenced Rear Panel Outlets

6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)

AC Surge Protection

Merit Class (sacrificial)

Spike Protection Mode

Line to neutral, zero ground leakage

Maximum Continuous Operating Voltage

130V RMS

Max Clamp Voltage

500 Volts Peak

Peak Impulse Current

12,000 Amps

Energy Rating (2 X 820µS)

225 Joules

AC Filtering

Pi LCR Filter

Noise Attenuation

>26dB, 100 Khz to 1 MHz

Operating Temperature Range

5°C (40°F) to 40°C (105°F)

Humidity Range

<90% rH (Relative Humidity)

Rocker Switch

Front panel, Sequence (ON, OFF)

Thermal Circuit Breaker

Front panel, push to reset

Front Panel Indicators

Delay 1, Delay 2, Delay 3, Power, Protection OK

Control/Status/Triggering (Rear Panel)

Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained

Potentiometer

Rear panel, time calibration fine-tune delay adjust

Remote Terminal

+5-30VDC In, 12VDC (12mA) Out

Remote Terminal Connector

Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)

Size

1.75” x 19.00” x 6.5” (HWD) – ANSI 1RU

Mass

5.3 lbs.

Power Consumption (No Load)

5 Watts

Safety Agency

C/CSA/US

UPC

654061041078

Proposition 65 Warning

WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

3Year Limited Warranty

Important Note for Internet Purchasers

 

  • YOUR FURMAN WARRANTY WILL NOT BE VALID IF YOU PURCHASE A FURMAN PRODUCT FROM AN UNAUTHORIZED AUDIO VIDEO INTERNET DEALER, or if the original serial number has been removed, defaced or modified.
  • Only authorized dealers provide NEW Furman products — not used or refurbished — and have the training and expertise to assist you in selecting the correct model for your application. They also have the knowledge to correctly answer any questions regarding proper installation and ensure that your Audio Video system is fully protected. Purchase your Furman product from one of our Authorized Online dealers.
  • Note: Furman products purchased through auction sites DO NOT have a valid warranty.
Title

SAVE YOUR SALES RECEIPT

 

The receipt is your proof of purchase and confirms the product was purchased at an authorized Furman dealer. It will need to be submitted to Furman in order to process any warranty claims. Online registration is no longer required for any Furman products.

Furman product warranties vary by model/product family. See below for warranty length by product family. Warranty term begins upon date of purchase on sales receipt. For specific warranty terms and conditions or for warranty information on products not listed below please see your product manual.

Resources

Manual:

Datasheet

Special Features

15A Standard Power Conditioner with Sequencer

Power Sequencing

Prevents excessive inrush currents

Noise Filtration

Noise filtering to reduce radio frequency and electromagnetic interference

Surge Protection

Ensures equipment stays safe

9 Total Outlets

Six sequenced rear panel outlets (in three groups), two unswitched rear panel outlets, and one front panel unswitched outlet

15 Amp Rating

15 amp rating, with circuit breaker

“Protection OK” Indicator

Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status

Wall Wart Spacing

Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status

Easy Setup

All settings and configurations available on rear panel